|

Behind the Colour: How We Tie Dye Our T-Shirts

Tie dye can look spontaneous, but there’s actually a fair amount of preparation involved before the colour ever touches the fabric.
For us, the process starts well before the tying and dyeing.

Why We Start With 100% Cotton

The first thing is the fabric itself. For the type of dyeing we do, the T-shirts need to be made from 100% natural fibre, ideally cotton.
That’s because the dyes we use are designed to bond with cellulose fibres. Cotton is made from cellulose, so the dye can chemically attach itself to the fabric rather than simply sitting on the surface. Synthetic fibres such as polyester behave very differently. They don’t react with the dye in the same way, which means the colour can come out weaker, uneven or fail to take properly at all. So if we want strong, vibrant colour that lasts, starting with the right fabric is essential.

What the Soda Ash Actually Does

Before we dye anything, the T-shirts are soaked in a mixture of soda ash and water for at least 48 hours.
Soda ash raises the pH of the fabric, making it more alkaline. That creates the right chemical conditions for the dye to react with the cotton fibres and form a much stronger bond.

Without that stage, the dye may still colour the fabric, but it won’t fix as effectively and the final result can be much less vibrant or durable.
Once the soak is complete, the garments get a quick spin in the washing machine to remove excess liquid without fully washing the soda ash back out.

Tying the Pattern

Next comes the part that gives each T-shirt its character.

The garment is folded, twisted or tied depending on the pattern we want to create. This is where the design starts to take shape, but there’s always an element of unpredictability involved. You can control the fold, the placement of the ties and where the dye goes, but you never know exactly how the colour has travelled through the fabric until the shirt is finally opened up.

That’s part of the appeal.

Small Batches, Stronger Colour

We deliberately work in small batches rather than producing large runs.

That allows us to concentrate the dye more effectively across a smaller number of garments and gives us more control over the strength, consistency and overall quality of each shirt.

The downside is that we only ever have a few of each design and size.

So if your size sells out, that may genuinely be it.

The upside is exactly the same thing.

There are only a limited number of each design, which means you’re far less likely to see the same shirt everywhere else.

For us, that limited-run nature fits perfectly with what Stampy’s Shop is about.

Adding the Dye

Once the shirt is tied, the dye is applied.

This is the point where all the preparation starts to pay off.

After dyeing, the garment is left for a minimum of 24 hours so the dye has plenty of time to react with the cotton fibres and develop properly.

Rushing this stage can reduce the strength of the colour, so patience matters.

The Rinsing Process

Once the dye has had time to set, the shirt is rinsed by hand while it is still tied.
This removes a large amount of excess dye before the pattern is opened up.

Then comes the best part: the ties are removed and the design is revealed.
The shirt is rinsed again by hand to remove more loose dye before going through a rinse-and-spin cycle in the washing machine.

The Final Wash

The final stage is a low-temperature wash using Jacquard Synthrapol detergent.

This helps remove remaining loose dye from the fabric and gives the garment its final clean before it is ready to wear.

By the time one of our tie-dye T-shirts reaches the shop, it has been through several stages of soaking, preparation, tying, dyeing, resting, rinsing and washing.

It’s a slow process, but that’s really the point.

We’d rather make a small number properly than rush out a large batch.

And because every shirt reacts slightly differently, no two ever come out exactly the same.

Mr Stampy

Similar Posts